What we offer
Grease trap cleaning services in Monroe & West Monroe, LA
Commercial interceptor cleaning, FOG education, and honest Free Estimates for Twin Cities kitchens — from under-sink units to outdoor tanks.
Routine grease trap cleaning
Scheduled removal of FOG and solids with plain-language notes on what we found. Ideal for restaurants that want predictable intervals.
Catch-up / overdue service
When the last visit was too long ago or you’ve inherited an unknown trap. We’ll scope access and load before promising a time window.
Under-sink interceptor service
Compact café and food-hall units — faster stops, still careful about baffles and refill readiness.
Outdoor / in-ground tanks
Higher-capacity interceptors with lid and traffic planning built into the visit.
Guides: how often, FOG basics, pumping vs cleaning.
What a full cleaning includes
Every service visit follows the same steps. We locate and open all lids and access points. We measure the depth of the floating grease layer and the settled solids and note them on your record. We pump out the trap’s contents, including grease, water and solids. We scrape grease from the walls, lids and baffles, and remove solids packed in corners and at the bottom. We check that the inlet and outlet are clear and that baffles, tees and flow-control fittings are present and intact. We close and secure the lids, clean up around the work area and give you a dated record of what we did and found.
This is different from pumping only. Pumping removes liquid and loose grease but leaves hardened grease on walls and baffles and solids at the bottom. Those deposits take up space and shorten the time until the trap is full again. Read more in our pumping vs cleaning guide.
Under-sink traps
Hydromechanical traps under or next to a sink are common in cafés, bars, small takeout kitchens and convenience-store food counters. They are compact and easy to reach, but they hold little grease and fill quickly. Each has a removable lid, internal baffles and usually a flow-control device on the inlet that keeps water from rushing through too fast. Staff sometimes remove baffles or the flow control to speed up drainage, which stops the trap from working. During each visit we check that every part is in place and the gasket seals properly. Many under-sink traps need cleaning every week or two. See our under-sink trap guide.
Outdoor and in-ground interceptors
Larger restaurants, schools, hospitals and institutional kitchens usually have a gravity interceptor buried outside, often under a parking lot or drive-through lane. These tanks hold hundreds or thousands of gallons and may have two or more compartments. All compartments need cleaning. We plan truck placement so we don’t block customers or deliveries, and we schedule during slow hours. Concrete interceptors in hot climates can corrode above the waterline from acids and gases released by decomposing grease. We look for crumbling concrete, broken baffles and cracked lids, and tell you if something needs a plumber or contractor. See our outdoor interceptor guide.
Setting the right interval
There is no single correct schedule for every kitchen. A common guideline used by many sewer utilities and pumpers is to clean before the grease and solids layers together take up about 25 percent of the trap’s liquid depth. Beyond that point, separation drops off and grease starts leaving the trap. The best way to set your interval is to measure. We record the layers at each visit. If the trap is barely a tenth full, the interval can be lengthened. If it is at or over a quarter, it should be shortened. Menu changes, longer hours, a new dishwasher or added sinks can all change how fast your trap fills. See how often to clean a grease trap.
Rules, inspections and records
Grease traps are covered by several sets of rules. Louisiana’s plumbing code, part of the state’s uniform construction code, requires grease interceptors for food-service operations that discharge grease. The Louisiana Department of Health inspects retail food establishments. Local sewer utilities, including those run by the cities of Monroe and West Monroe, have their own requirements for what may enter the sewer. Requirements differ by location, so confirm the rules that apply to your business with your local utility and plumbing inspector. We don’t issue permits or certifications.
What every kitchen can do is keep good records: the date of each cleaning, the company, the layers measured, anything found and the receipt or manifest showing where the waste went. Keep them in one place where a manager can find them on inspection day. See FOG compliance basics and inspection prep.
Where the waste goes
Grease trap waste must be transported to a facility approved to receive it. It must never be dumped into storm drains, ditches, sewer cleanouts or onto land. Ask any service company where the waste goes and keep the paperwork. Used fryer oil is different: it is collected separately, usually by a renderer or recycler, and should never go into the grease trap. Keeping those two streams separate lowers the load on your trap and the cost of service.
Odors, backups and urgent calls
If your kitchen has a sewage backup, stop running water into the affected drains and call a plumber first. Once the line is cleared, the trap can be cleaned. Strong odors, slow drains and grease showing at floor drains are signs that the trap is full or that a line is partly blocked. Call before it turns into a backup. Odors get worse in summer, when heat speeds up decomposition, so a schedule that works in winter may need to be shortened in July and August. See our guides to smells and backup signs and overflows.
Who we work with
Our customers include restaurants, cafés, bars, bakeries, caterers and commissary kitchens, convenience stores with hot food, school and institutional kitchens, churches with fellowship-hall kitchens, and event venues. We serve Monroe and West Monroe and the surrounding communities in Ouachita Parish, plus Rayville in Richland Parish. If you have several locations, we can coordinate a schedule and records for all of them.
Getting a Free Estimate
Tell us your business name and town, whether the trap is under a sink or outside, its size if you know it, how often it is cleaned now and any problems you have had. We will suggest a starting schedule and give you a price. Price depends mostly on the trap size, how full it is, access to the lids and how far we travel. See the cost guide for the factors involved.
Kitchen habits that stretch your interval
The cheapest grease is the grease that never reaches the trap. Scrape plates, pots and pans into the trash before washing. Wipe greasy pans and fryer baskets with paper towels. Let fat in pots cool and harden, then scrape it out. Use strainers in all sinks and floor drains and empty them often. Collect used fryer oil in a container for recycling, never in a drain. Use pre-rinse sprayers only after scraping. Keep food waste out of garbage disposals that drain to the trap. Train every new employee on these habits on the first day, and post a short sign over the dish sink. Kitchens that follow these steps often see their cleaning interval grow, which saves money over a year. See our kitchen FOG habits guide.
Restaurants changing hands
When you buy or lease an existing restaurant, the grease trap often comes with no records and an unknown history. Grease may have hardened in the trap and lines, baffles may be missing and the lid may be cracked. Start with a full cleaning and inspection before you open. We measure the trap, check its parts and tell you what we find, so you can set a schedule and budget for any repairs before the first busy weekend.
Seasons and busy weeks
Kitchen volume in the Twin Cities rises around holidays, football weekends, university events and festivals. More meals mean faster filling. If you know a busy stretch is coming, schedule a cleaning just before it, so the trap starts empty. Summer heat adds odors and speeds up decomposition in the trap, so many kitchens need a shorter interval from June through September. Heavy rain is another risk: a cracked lid or low cleanout can let stormwater in and push grease out. Check your lids after big storms. See our seasonal care guide.
What we don’t do
We clean and inspect grease traps and interceptors. We don’t install, replace or resize traps, repair drain lines or clear sewer blockages; those jobs go to a licensed plumber. We don’t issue permits or compliance certificates. When we see a problem outside our scope, such as a broken baffle, a corroded tank or a line that stays slow after cleaning, we note it on your record and tell you who to call.
Multiple locations and property managers
Restaurant groups, franchise owners and property managers with several kitchens can put all their traps on one coordinated schedule. Each location gets its own interval, based on measured layers, and its own dated records. That makes it easier to budget, to answer questions from inspectors or landlords and to spot a location whose trap fills unusually fast, which often points to a habit or equipment problem worth fixing. For shopping centers with shared interceptors, we can work with the property manager and tenants to agree on a schedule and share the records.
Safety on every visit
Grease traps and interceptors release gases as grease and food break down, including hydrogen sulfide, which smells like rotten eggs and can be dangerous in enclosed spaces. Open lids can be a fall hazard. During service we keep the area around open lids marked and supervised, keep staff and customers back, and close and secure every lid before we leave. Never let employees climb into an interceptor or lean deep into an open manhole. If a lid is cracked, loose or missing, keep people off it and have it replaced promptly.
Service questions
Can you clean the trap before we open?
Yes. Early-morning visits before opening, or after closing, are often the easiest. Tell us your hours and we will plan around them.
Do I need to be there during service?
Someone needs to let us in and show us the trap if it is indoors. Outdoor interceptors only need clear lid access.
Will you tell me if my trap is damaged?
Yes. We note cracked lids, broken baffles, missing flow controls and corroded concrete on your record, and recommend a plumber or contractor for repairs.
Do you provide a record for inspectors?
Yes. Each visit comes with a dated record showing what was removed, the layers measured and anything we found.
When you’re ready
Request a quote
Share your city and what you’re seeing — we’ll send a Free Estimate.
Request a quoteOr call (318) 327-2215